This release - provides improved support for the Icom IC-910H and IC-9100, including the ability to control Satellite Mode (tnx to Bill G4WJS and Mark AA3RK) - when starting up while controlling an Icom transceiver that reports its filter status as "wide", correctly sets the Group selector in the Main window's Filters panel (tnx to Jim AF5FH) - when processing a SetRXFreq or SetTXFreq command received via TCP, doesn't issue VFO selection commands unless necessary (tnx to Bill G4WJS) - closes all TCP connections before terminating (tnx to Bill G4WJS) - ensures correct termination when more than one primary transceiver has been activated (tnx to Bill G4WJS) - ensures that the primary and secondary CAT ports are released at termination (tnx to Bill G4WJS) - doesn't add a new frequency to the Band Stack when a Band button in the Bandspread window is clicked (tnx to Tim NZ8J) - ensure that frequencies are correctly "pushed" onto the Bandspread window's band stacks (tnx to Tim NZ8J) - provides an indication in the Bandspread window's Band panel when QSYing causes a frequency to be saved on the current band's stack (tnx to Tim NZ8J) - accepts a CmdQSXSplit command via TCP that sets the TX frequency, split and dual in a manner that works with all supported transceivers (tnx to Bill G4WJS) - when QSYing to a new frequency and mode while controlling a Yaesu FT-450, FT-950, FTDX-1200, FT-2000, FTDX-3000, FTDX-5000, or FTDX-9000, issues a BandSelect CAT command if the new frequency is not on the same band as the current frequency (tnx to Art W2NRA, Tim NZ8J, Paul NN4F, Gary NC3Z, Tom KQ5S, Chuck NM4M, Brian N8WRL, Paul G4YKQ, Bruce K5WBM, John W5UP, and Kevin KW0KW) - when controlling a TS-990 or TS-2000, polls for "Auto Mode" every 10th poll cycle; if "Auto Mode" is enabled when changing frequency and mode, issues a "change mode" command after changing the frequency (tnx to David K2DSL) - supports the Kenwood TS-590SG (tnx to Ian G3NRW) - supports the Hilberling PT8000 - supports a fourth frequency-dependent device (tnx to Mike K9UW) - updates the Configuration.htm documentation file Commander 11.1.5 is available via the DXLab Launcher and via 73, Dave, AA6YQ