This release - adds an FT990_12 radio model for an FT-990 runing firmware revision 1.2 (tnx to Darren G0OTT) *** when polling, doesn't request frequency or mode *** provides a Main window button to request frequency and mode *** doesn't direct the radio to report its frequency when after adjusting its frequency with the VFO arrow buttons or via the mousewheel - adds Pegasus_N4PY support for RTTY mode (tnx to Jerry KG6TT) - expands Elecraft K3 support (tnx to Joe W4TV, Rich VE3KI, and Steve K4QL) *** uses the SWT13 command to implement A>B *** uses the SWT11 command to implement AxB and XFC *** when receiving an FT command, updates split status *** uses the FT0 and FT1 commands to set split status *** provides filter width and shift controls in the Main window's Filters panel - provides a user-defined sequence that is optionally executed on startup or whenever a new transceiver is selected - enables command sequences to set the value of any slider - provides the ability to include a slider's current value in its label and/or its label's explanatory popup - enables a command in a command sequence to specify the Name and Tooltip of any other command sequence - provides the ability to run a user-defined command sequence by clicking a button in the sequence editor - permits slider value substitution strings, ascii substitution strings, and CI-V address substitution strings in Command Sequences and in the Initial Command - permits CI-V address substitution strings in Slider-generated commands - accepts directives from other applications that set a Slider to a specified value - updates the CommandSequences.htm, Configuration.htm, and ExampleToggleCommand.jpg documentation files Note: the next release of WinWarbler provides an macro command that lets you set the value of a specified slider Commander 7.2.9 is available via the DXLab Launcher and via 73, Dave, AA6YQ