This release - when responding to a QSX directive from another application when the active transceiver is a Kenwood TS-940, selects VFO A after enabling split (tnx to Cliff K3LL) - provides the option to suppress the use of CAT commands to switch between RX and TX (tnx to Joe W4TV) - defines the new radio model FTDX9000P1, which supports the Yaesu FTDX-9000 PEP with version V08 firmware by removing "padding" no longer required by its upgraded processor (thanks to Lou N2TU) - improves the Elecraft K3 polling sequence by including the K31 command in case the transceiver is powered off and back on, and increases the frequency of IF and FB commands (tnx to Joe W4TV) - updates the Configuration.htm online documentation file Commander 7.4.9 is available via the DXLab Launcher and via 73, Dave, AA6YQ