This release - ensures the correct update of Commander's Main VFO when responding to a "set QSX" directive -- e.g. when double-clicking a split spot database entry -- with no band change and an Icom transceiver (tnx to Bob KB1JZU) - properly displays the S-meter reading from an Elecraft K3 now that K31 mode is always enabled (tnx to Joe W4TV) - provides an improved K3 S-meter file (tnx to Joe W4TV) - enables CW transmission via a K3 when an LP-bridge is present and enables the K3's K22 mode (tnx to Joe W4TV) - for Kenwood and Elecraft transceivers, indicates to other applications that the transceiver has switched from RX to TX or TX to RX if the switch was accomplished via the radio's front panel or PTT signal (tnx to Sebastian NS0W) - provides the option of signaling to other DXLab applications that the current transceiver is an Icom or Icom-emulating TenTec currently in split mode that does not report the transmit VFO when operating split, and provides a DDE operation that allows such applications to update their view of both VFOs prior to logging or spotting (tnx to Jamie W2QO, Ken K4XL, and Paul VE1DX) - updates the Configuration.htm online documentation file If the active transceiver is an Icom or Icom-emulating TenTec, then a new "Synchronize transceiver frequencies before logging or spotting" option will appear in the Radio panel on the Config window's General tab. If you enable this option, then when Commander shows your transciever to be in split mode, DXKeeper and WinWarbler and SpotCollector will all direct Commander to refresh its and their view of both transceiver VFOs before they initiate a log or spot operation, ensuring that the frequencies logged or spotted are accurate. Note, however, that this does not overcome Commander's inability to determine whether or not your Icom/TenTec transceiver is in split mode when you make changes via the transceiver's front panel. Commander 7.4.4 is available via the DXLab Launcher and via 73, Dave, AA6YQ