This release

- properly labels the Main window's VFO panels when controlling an Icom transceiver with VFOSel commands or a TenTec Omni VI transceiver with Split enabled (tnx to Rich W3ZJ)

- adds "Omni VI" to the Secondary CAT port's protocol selector; when following a primary transceiver that has been set to CW-R mode, sets the Omni VI to CW mode (tnx to Jeff N8CC)

- when controlling an Elecraft K3 and directed to set VFO B by another application, sets VFO B's mode to that of VFO A

- display an Elecraft K3's RTTY submode in the Main window's Mode panel (tnx to Joe W4TV)

- when controlling a an Elecraft K3 transceiver, provides Data-L and Data-U buttons in the Main window's Mode panel (tnx to Joe W4TV)

- when controlling an Icom transceiver that supports Data mode, provide Data-L and Data-U buttons in the Main window's Mode panel (tnx to Jamie W2QO)

- when controlling an Icom transceiver that supports Data mode with multiple submodes, provides a Data submode panel on the Config window's General tab that determines which submode is selected when the mode is changed to Data-L or Data-U

- provides a selector that specifies the Log Mode for PKT, PKT-R, Data-L, and Data-U (tnx to Joe W4TV)

- accept Data-L and Data-U in commands from other applications

- updates the ChangingMode.htm and Configuration.htm documentation files


Note: the forthcoming SpotCollector 5.5.2 and WinWarbler 6.9.5 permit the specification of Data-L and Data-U transceiver modes if Commander's primary transciever supports them.

Commander 8.8.3 is available via the DXLab Launcher and via 

<http://www.dxlabsuite.com/download.htm>

     73,

          Dave, AA6YQ