This release - when handling a "new station" directive from SpotCollector, ensures that the operating mode change is complete before populating the QSO Info panel (tnx to Ken K5WK) - when switching to a PSK mode, sends Commander a "set frequency and mode" command rather than send individual "set frequency" and "set mode" commands so that transceiver-specific order requirements are satisfied (tnx to Ken K5WK) - if a grid square is specified in the "Position and Vector Configuration" window's position panel, or if DXKeeper [8.8.7 or later] is running and specifies the operator's grid square, includes the operator's grid square in the notes of spots whose frequency is 50 mHz or higher - provide separate audio frequency markers for PSK and RTTY (tnx to Joe W4TV) - provides a "log Special Callsign Tags" option that governs whether special callsign tags reported by DXView [3.4.3 or later] and SpotCollector [5.3.7 or later] are appended to the QSL Info panel's Comment textbox; DXKeeper 8.8.7 or later is also required (tnx to Vlad UA6JD and Stan N1ZX) - updates the GeneralSettings.htm, Logging.htm, LogSettings.htm, SoundardPSKSettings.htm, and SoundcardRTTYSettings.htm Note: in previous releases, double-clicking a Spot Database Entry that specified one or more Special Callign Tags and whose mode was "serviced" by WinWarbler caused WinWarbler to place those Special Callsign Tags in the QSO Info panel's Comment textbox; in this release, that will only happen if the new "log Special Callsign Tags" option is enabled on the Config window's Log tab. WinWarbler 6.8.2 is available via the DXLab Launcher or via 73, Dave, AA6YQ